A Lumin Smart Panel (LSP) communicates its connectivity status via two LED lights on the side of the unit. The blue light indicates connectivity to the internet and the green light indicates connectivity to Lumin servers. If both lights are blinking simultaneously, it indicates that the LSP is in Setup Mode. If this occurs after initial setup, it likely means that the WiFi button (for Gen 6.1 LSPs and prior) or Setup button (for Gen 7 LSPs and later) has been pushed.


To reconnect to the WiFi network:

  1. Press and release the WiFi or Setup button one additional time.
  2. Allow 45 seconds to pass for both lights to turn solid.
    • Note that a variety of other blinking combinations may be observed while WiFi is reconnecting.


If the system is offline because there is a new WiFi network name, password, or router, follow the procedure in this article to re-establish a connection:


www.luminsmart.com